By the end of this guide you will be able to frame any trade as a risk reward ratio before you take it. You will know where the stop belongs, how far the target can honestly sit, and how to draw both on a TradingView chart so you can see the ratio, not guess it.
The ratio is simple arithmetic. The skill is in the two choices that feed it: where the idea is proven wrong, and where price has a real reason to travel. Most of this guide is about those two choices.
What the ratio measures and the simple formula
The risk reward ratio compares what you stand to lose if the trade fails with what you stand to gain if it works. Both are measured from the entry: the distance to the stop is the risk, the distance to the target is the reward.
The formula is reward divided by risk. If the target sits three times as far from the entry as the stop does, the trade is framed at 1:3. If the target sits exactly as far as the stop, it is one to one.
The ratio says nothing about whether the trade will work. It tells you how much a winner pays relative to a loser. That matters because it decides how often you need to be right. At 1:3, one winner covers three losers before costs, so a trader can be wrong more often than right and still keep the account level. At one to one, there is no such cushion.
This is why the ratio is a planning tool, not a forecast. You set it before the trade, while you can still walk away. If the numbers do not work, you skip the setup. For how this sits inside a full risk plan, see our risk management guide.
Same entry, two stop distances
Here is the point most traders miss: the stop sets the ratio more than the target does. Targets are limited by the chart. Stops are where traders get creative, and that is where the ratio quietly changes.
A worked example on Bitcoin, hourly chart
Take Bitcoin on the hourly chart. Price has pulled back into a zone where an earlier rally started, and the next swing high above is the obvious target. The entry is at the top edge of that zone.
- Stop A goes just beyond the bottom of the zone. The risk is the height of the zone plus a small buffer.
- Stop B goes below the swing low further down, roughly twice as deep as Stop A.
- The target stays at the same swing high in both cases.
With Stop A, say the trade frames at 1:3. With Stop B, the risk has doubled while the reward has not moved, so the ratio is cut in half. Same chart, same entry, same target, and one trade pays twice as much per unit of risk as the other.
Which stop is right
Neither is right by default. Stop A is right if the zone is the reason for the trade: if price closes through it, the idea is dead, and there is no reason to hold until the deeper low. Stop B is right only if the trade idea is built on that lower swing, not on the zone.
The rule: the stop goes where the reason for the trade stops being true. Then the ratio is whatever the chart gives you. You never move the stop closer just to make the ratio look better.
Placing the stop beyond the level, not inside the noise
A stop placed exactly on a level is a stop placed where everyone else put theirs. Clusters of stops just past obvious highs and lows are liquidity, and price often reaches into them before deciding direction.
The rule
Place the stop beyond the level, past the wicks that already tested it, not on the line itself. Look left on the chart: if earlier wicks pierced the zone by a certain amount and price still turned, your stop belongs past those wicks. Inside that range is noise, not invalidation.
A second check is the candle close. A wick through your level is not the same as a close through it. If your method treats a close beyond the zone as the failure, your stop has to sit far enough out that a wick alone does not take you out before that close prints.
A worked example on the Dow, 15-minute chart
On the Dow on the 15-minute chart around the New York open, price often trades into a prepared zone, spikes past its edge, then reverses. A short taken from a sell zone with the stop sitting on the zone's top edge gets taken by that spike. The same short with the stop past the top of the zone and past the wicks that already tested it survives the spike and is only stopped if price truly breaks the zone.
The cost is a wider stop and a lower ratio. That is the honest price of a stop that means something. If the wider stop makes the ratio too poor, the answer is to skip the trade, not to tighten the stop back into the noise.
If you want to see where those stop clusters sit, the free ICT Liquidity Levels indicator marks buy side and sell side liquidity and equal highs and lows on the chart.
TradingView Indicator Library
35 ICT, Wyckoff and Fibonacci indicators — 29 of them free — with screenshots, guides and FAQs.
Drawing the ratio on a TradingView chart
TradingView has two drawing tools built for this: Long Position and Short Position, found in the prediction and measurement section of the left toolbar. Each draws an entry line, a red risk box and a green reward box, and shows the ratio on the drawing.
Step by step
- Choose Long Position or Short Position and click on your entry price.
- Drag the red box edge to your stop: beyond the level and past the wicks, as above.
- Drag the green box edge to your target: the next level where price has a real reason to react, such as a prior swing high or low.
- Read the ratio on the drawing. If it does not meet your minimum, delete the drawing and wait.
- Open the settings to enter your account size and risk per trade, and the tool calculates the position size from the stop distance.
That last step is the one that protects the account. Your stop distance sets the size, not the other way round. A wide, honest stop means a smaller position; a tight stop allows a larger one. The money at risk stays the same either way.
To practise this, draw the boxes on your own chart before your next trade with a free FibAlgo account and the free FibAlgo indicators from TradingView loaded, so the levels you frame against are already on screen.
Common mistakes when sizing the target
The stop is where the ratio is usually ruined, but the target is where it is usually faked. A ratio of 1:3 means nothing if the target sits somewhere price has no reason to go.
Mistake one: the target is picked to fit the ratio
A trader wants 1:3, measures three times the stop distance, and puts the target there, in empty space. The fix: find the target on the chart first, at the nearest opposing level, then read the ratio. If it comes out too low, the trade is not there.
Mistake two: the target sits past an obvious level
A long whose target is above a prior day high has to break that high first. Many moves stall at the first opposing level. The fix: put the target before the first real obstacle, or treat that obstacle as a partial exit and the level beyond it as a second target.
Mistake three: moving the target mid-trade
Price approaches the target, the trader decides it will go further, and moves it out. Now the trade's reward is open-ended while the risk was fixed. The fix: if you want to hold for more, close part at the planned target and trail the rest with a stop that locks in progress.
Where the setup fails
Even a well-framed ratio fails. The signs show up before the stop is hit: price returns to your zone with large, fast candles instead of a slow pullback; the zone has already been tested several times and each bounce is weaker; or the higher timeframe trend runs straight against the trade. When you see those, the ratio on the drawing is still correct, but the odds behind it have changed. Skipping that trade is part of the method. Our guide to common trading mistakes covers more of these patterns.
Letting an indicator frame the setup
Everything above can be done by hand: mark the zone, find the invalidation, find the opposing level, draw the boxes. The hard part is doing it the same way every time, especially when price is moving fast and the temptation is to chase.
This is where traders ask whether there is a tool that draws the frame for them. The R:R Trading System, an exclusive indicator on fibalgo.com, draws volatility-adaptive support and resistance, shades the pullback entry zone, and frames each setup's entry, stop and target on the chart. The stop it draws sits past the zone rather than on its edge, which is the same rule this guide teaches.
An indicator does not remove the judgment. You still decide whether the zone matters, whether the higher timeframe agrees, and whether the ratio it shows is worth taking. What it removes is the inconsistency of drawing the frame differently every time. If you build your zones from Fibonacci levels, how to use Fibonacci retracement in TradingView shows how to mark them before the trade.
Frequently Asked Questions
What is a good risk reward ratio in trading?
How do you calculate the risk reward ratio?
Should I tighten my stop to get a better risk reward ratio?
Does TradingView have a risk reward tool?
Related indicators
ICT · Wyckoff · Fibonacci
Put What You Learned Into Practice
Apply these ideas on your own charts with FibAlgo's TradingView indicators.
- Traders
- 5,000+
- Indicators
- 35
- Free Indicators
- 29
Free account. Free indicators included.